Hello everyone! We have a great idea for you all. It’s super easy and quick. DIY phone charger holder would be perfect for giving a gift! Or you could make one up for you! Don’t be nervous about sewing and making it perfect! I’ll tell everything what you need. So let’s get it started together 🙂
Step 1: First of all, we should complete the materials. You’ll need:
- Fabric (Main Front and Back -2 pieces 10 1/2″ x 6″ || Pocket Front and Back-2 pieces 7″ wide at top and 6″ wide at the bottom, and 5″ tall)
- Fusible Fleece -one piece 10 1/2″ x 6 and one piece 7″x5″
- Ribbon -10″
- Pom Pom Trim-30″
- 1 Plastic Curtain Grommet
To start, cut all of your fabrics. Then cut fleece pieces too. Iron the fleece to the back side of one of the pocket pieces and one of the main pieces.
Step 2: Sew the two pocket pieces together just along the top edge.
Step 3: Sew the ribbon 3/8″ down from the top edge,along both sides of the ribbon.Form a little bow with the extra ribbon and hand sew the bow in place.
Step 4: Place the front pocket on the front main piece and line up the bottom edge and the sides.Sew the sides and bottom down with a 1/4″ seam allowance.
Step 5: Use a spool of thread as a guide. Trim all four corners so they’re rounded. Sew your pom pom trim around the edges.(3/8″ in from the edge) Make sure the pom poms are pointing towards the center.
Step 6: Pin the back main piece to the front main piece. Sew around the sides and leave an 2″ opening on one side,above the pocket. Turn it the right side out through the opening!
Step 7: Put the curtain grommet in place,following the instructions on the package. These just snap into place.
And that’s it! You have a super useful and cute phone charger holder. This is super safe place for your phones!
Hope you like it and I hope that it’ll useful for you. Thank you for reading this and see you in next article:)!.